Hello,
I was wondering if it's possible to attach the little "hanging" part of the AK5 coin collector...
It attaches to the main coin collector part with a few wires, but I am concerned that it hangs down and over time the wait of the attached serial cable and power cable will pull out the pins.. and also that it hangs directly under the slot where the coins exit the AK5 device.
I'm also worried that if it ever touches the metal sides of the box the coin collector is in, that it will short out and be ruined.
Is there any way to attach this to something so it's out of the way? Do you think I could use some sticky tape on the side of the collector?
I don't want to short out the electronics or anything...
Thanks!
Suggestion to "fix" the hanging chip part of the A
-
- Posts: 386
- Joined: Mon Jan 15, 2007 6:38 pm
There is a screw on top left corner the coin acceptor AK5,
You can take that off and put the hanging part on and screw it on again.
The hanging parts is designed to fit there, however some customers need to fix it some where else on their cabinet.
you may need another longer screw if the original screw is not longer or tight enough.
thanks for your question about it.
You can take that off and put the hanging part on and screw it on again.
The hanging parts is designed to fit there, however some customers need to fix it some where else on their cabinet.
you may need another longer screw if the original screw is not longer or tight enough.
thanks for your question about it.
-
- Posts: 386
- Joined: Mon Jan 15, 2007 6:38 pm
-
- Posts: 386
- Joined: Mon Jan 15, 2007 6:38 pm
Re: Suggestion to "fix" the hanging chip part of the A
The new version of interface board is available